July 8, at 4: Sneh Cook Republic says: Required, not published Homepage: And the ad was just amazing……. Donc vous m’avez oublié comme ça? Wish you the best of luck!

Nom: mimi do like i do
Format: Fichier D’archive
Système d’exploitation: Windows, Mac, Android, iOS
Licence: Usage Personnel Seulement
Taille: 45.10 MBytes

I had no desire to feel her close to me, I became hysterical I knew she touched me I might have done something I would regret next, I always knew I was vindictive but I confirmed to what Degree this day. En tout cas je compte sur vous. My sister is free to choose if she accepts you or not in any case you are my wife and not hers then I don’t see why you worry. How about you two sit like grown-ups , figure it out. Pasquetmorgane Il y a 3 an s 4 mois à

mimi do like i do

Requires adapter plate included with the Innofader kit 2: Use included flathead screws for more headroom between the mixer faceplate and the crossfader plate. Requires power from the Innofader crossfader cable included with the fader 4: Curve adjustment works in reverse, so sharpening the Innofader curve actually softens the audio output curve 5: Fader body and adapter must be fully isolated from internal circuits with insulating screws and insulating washers.


Requires jumper wires from Audio Innovate, please inquire directly at support audioinnovate.

Multiple Innofader models will work for this co. The preferred model is specified. Requires wiring modification using mini flathead screwdriver included with the fader.

Please see mixer specific insructions for more detail. Requires hand soldering modification to connect mixer power.

Please see mixer specific instructions for more detail. Please also order the Innojuster to get a full range of curves.

Dj Zoumanto Feat KO-C & MIMIE – DO LIKE I DO *-*

Insert the crossfader cable into the 3 pins on J13 closest to the Innofader cable original Innofader only Either works with the original Innofader or new Innofader Pro indicated by a small green sticker on the packaging top right corner Need to drill holes spaced 65mm apart to mount Innofader Need to raise the fader plate by 1mm to fit the Innofader.

Adapter plate available direct from Audio Innovate. Please inquire support audioinnovate. Please use the special 4 pin white locking cable included with the Innofader PNP2 kit.


Also fits the original Innofader Pro.

Do Like I Do

Please follow the instructions for VCA hookup Please connect the single 3 wire connector to the outermost connector on adapter 15 to prevent short circuiting. Fit is not perfect, and you will need to clip away the unused pins DJM 3 wire cable needs to be soldered to the existing crossfader 3 wire cable Please write to support audioinnovate.

mimi do like i do

Please clip off unused solder pins so the mini Innofader Plus S can be installed properly.